Heading RCADev

 

HOME

PHANTOM UAV

VACUUM FORMING

OpenTX

CONTACT ME

 

 

Previous Page – SD Card

Next Page – Version

OpenTX Reference Guide 22 – Trainer

The Trainer Mode is set in the Trainer Port parameters on the Model Setup screen. It is set to either Master or Slave.

Master Mode

When the Trainer Mode is Master, the following parameters apply.

 

 

Mode

%

Source

Thr

 

 

 

Ail

 

 

 

Ele

 

 

 

Rud

 

 

 

 

FIELD

PARAMETER

Mode

OFF    Channel not used.

+=        Add the master channel to the slave channel.

:=         Replace the master channel with the slave channel

%

Use positive 100% for normal control. Use –100% to invert the channel.

Range is from –125 to +125.

Source

CH1, CH2, CH3, CH4  Assign which slave channel correspond to Thr, Ail, Ele & Rud.

 

Multiplier

  The multiplier value scales all of the channels by the same value.

  Range is from 0.0 to 5.0. Default is 1.0.

Cal

  incomplete

Slave Mode

When the Trainer mode is Slave, this screen simply shows the message ‘Slave’. No set up is required here, however refer to the Model Setup screen Trainer Port parameters for slave setup.

Cable

A stereo cable with 3.5mm plugs on each end is suitable as a trainer cable.

 

Phantom Divide

 

Previous Page – SD Card

Next Page – Version

 

Footer RCADev