Heading RCADev

 

HOME

PHANTOM UAV

VACUUM FORMING

OpenTX

CONTACT ME

 

 

Previous Page – Heli Setup

Next Page – Inputs

OpenTX Reference Guide 4 – Flight Modes

Flight Mode 0 is the default Flight Mode. Modes 1 through 7 can be enabled by the source parameter.

If Flight Modes 1 through 7 are not active, then flight mode 0 applies. Flight Mode 0 does not have a source.

Flight Modes are used in the Inputs and Mixer blocks to enable or disable lines.

Flight Modes can also be used as a Switch source for Logical Switches.

 

Flight

Mode

 

Name

 

Source

Rudder Trim

Elevator

Trim

Throttle

Trim

Aileron

Trim

Fade

In

Fade

Out

 

 

 

 

 

 

 

 

 

 

Each field is described in this table.

 

FIELD

DESCRIPTION

FM0 to FM8

Flight Modes 0 to 8.

Name

Flight Mode Name. 10 characters maximum

Source

SA …SH     switches A through H,

  = switch position forward

  - = switch position in centre.

  = switch position back

S31 .. S36 multi-position switch positions 1…6. (If fitted to analog input S3)

tRl, tRr, tEd, tEu, tTd, tTu, tAl, tAr,    trim switches,

! = NOT logical operator. (used in front of other sources)

Rudder Trim

---    no trim.

:0    trim range 0 to +8

Elevator Trim

---    no trim.

:0    trim range 0 to +8

Throttle Trim

---    no trim.

:0    trim range 0 to +8

Aileron Trim

---    no trim.

:0    trim range 0 to +8

Fade In

Transition time when this flight mode is enabled.

The range is from 0.0 to 25.0

Fade Out

Transition time when this flight mode is disabled.

The range is from 0.0 to 25.0

Check FM0 Trims

 Incomplete

 

Phantom Divide

 

Previous Page – Heli Setup

Next Page – Inputs

 

Footer RCADev